Mirroring a Bay Layout for a Left-Hander
Start with the center line of the screen. Treat the ball spot, the screen and the net as sitting on it only as a starting point. Don't skip the enclosure and launch device makers' instructions.
What flips and what stays
You flip where the golfer stands and where the club travels. The target line stays where it is.
- Draw the right-handed plan with the center line marked.
- Place the stance on the opposite side of the ball spot.
- Redraw the backswing and follow-through arcs on their new sides.
- Check each arc against walls, doors, light fixtures and the side of the enclosure.
- Compare the result with the enclosure and launch device manuals.
Anything on a wall that was clear of a right-hander's arc can sit in a lefty's. Lights and shelves are common culprits. Check them with the club, not the drawing.
Width figures to compare against
Makers and sellers publish width figures, and they differ. Treat them as figures to compare, not a rule.
| Source | Figure | Applies to |
|---|---|---|
| Trackman | 4.6 meters (15 feet) or more of width is "a strong benchmark"1 | A single golfer, either hand |
| BenQ | At least a 14 ft enclosure, 7 ft on each side of a central hitting area2 | Shared right and left use |
| SkyTrak | An extra 1' to 2' of width3 | When both hands will play |
If your room is narrower, one source notes that "offset hitting positions can help in narrower rooms"1. An offset position is only acceptable if it stays within the enclosure maker's and launch device maker's stated width, clearance and hitting-area figures. Do the club check for the offset spot itself, not the centered one.
Keep the hitting spot under the device
The device has a working area, and the ball has to sit inside it. One source says the hitting area "needs to align with the launch monitor sitting behind it"4. So if you slide the mat to give a lefty more room, check where the maker says the ball must be. The launch device page covers that check.
Check the back wall
Treat keeping the screen and net on the center line as a starting point for the layout only. Check the enclosure maker's instructions, and check every surface near the screen's edges. The side protection page explains how to cover them.
Test the flipped plan on the floor
Paper plans hide problems. Tape the center line and the stance marks onto the floor, then swing a real club slowly through the flipped arcs. Move the tape, not the walls, until the club clears everything.
Write down each distance you settle on. If you later share the bay with a right-hander, those notes show how far the mat can shift before the ball leaves the device's working area. Keep both sets of marks in different colors of tape so a changeover doesn't mean measuring again.
Do this before you buy or mount anything. Mounts for screens, projectors and nets follow the maker's instructions, and structural work belongs to a qualified tradesperson. The steps for the club check are on the page about swing space.