Where a Launch Device Sits for a Left-Handed Swing
It depends on the device type. Some stay put for a left-hander. Some makers' ground-based units move to the opposite side of the hitting area. Units that sit next to the ball must be repositioned and recalibrated. Your own manual has the final word.
Behind the ball
A launch monitor can sit behind the ball, on the target line. One maker's FAQ answers a left-handed owner directly: "Place the device the same way, 7.5 feet behind the ball"1. Handedness is then chosen in the app, which "uses this setting for its swing camera view"1.
That 7.5 ft figure comes from one maker's FAQ for one model. Other models differ: the same FAQ says the MLM2PRO "is designed to sit 6.5-8.5 feet directly behind the ball aimed down the target line"1. Read the manual for yours.
Separately, BenQ says radar-based launch monitors that sit directly behind the hitting area, and ceiling-mounted camera units, can switch hands without adjustment. The condition is that they stay lined up "with the area where the ball is going to be hit from"2.
Overhead
An overhead camera unit hangs over the hitting area. One maker says that for these, you assign "a handedness to the player profile"3. Nothing moves.
The ball still has to sit inside the area the camera covers. That area comes from the maker, so look for a diagram or a stated size in the manual. A mat that's been slid sideways for swing room can leave the ball outside it. Check the position again after every change to the mat. Ceiling mounts follow the maker's instructions, and anything structural needs a qualified tradesperson.
Ground-based units
Uneekor says that for its ground-based units you "will also need to move it to the opposite side of the hitting area"3. It adds a catch: a unit that "has been permanently affixed to the ground" can only serve one handedness3.
Monitors that sit next to the ball
This is a separate point from the one above, and it comes from a different source. BenQ says some launch monitors placed beside the ball must be moved and recalibrated when the player switches hands2. Read the setup section of your own manual and follow its calibration steps in order.
A short check
- Find the placement section in your device's manual. Look for the words "left-handed" or "handedness".
- Note where the device sits relative to the ball, with the distance and side the maker gives.
- Mark the ball spot on the mat and the device position on the floor.
- Set handedness in the app or on the device. The software page lists where.
- Hit a few slow shots and see if the first readings look sensible. The shot reading page explains what to expect.
If the manual is silent on left-handed use, ask the maker's support before drilling a mount. Don't guess a distance.